home > Services > Compressed Air Testing
Get your FREE quote today
Compressed Air Testing
ISO 8573-1:2010 specifies purity classes of compressed air with respect to particles, water and oil independent of the location in the compressed air system at which the air is specified or measured.
ZERO HIDDEN FEES - INSTANT SETUP
Compressed Air Quality Testing - What You Need To Know
COSHH regulations state that “As an employer, there is a clear responsibility under the requirements of the HSE to provide fit for purpose safety equipment for all employees that may work in an environment or carry out a process which may be hazardous to an employee’s health. Should an employer fail to provide and maintain this equipment, they will be liable for any damages claimed by an affected employee”.
In response to the above regulations, many employers provide respiratory protective equipment (RPE) to control exposure. This, however, is only the first step to compliance; the maintenance and testing of said equipment is vital as per the below standards.
BS EN 529 states that in the case of breathing air apparatus ‘the volume flow and quality of the air should be thoroughly tested at intervals as specified by a competent person’. Further to this, a reference is then made to the BS EN 12021 “Respiratory protective devices – compressed air for breathing apparatus” regarding air purity specification. The levels at which an employer’s breathing air is considered acceptable are affirmed as follows:
BS EN 12021
Should your site’s COSHH risk assessment require tests that are conducted on any specific contaminant levels, these can be conducted on request.
BS EN 12021 requires that “Compressed air for breathing apparatus shall not contain any contaminants at a concentration which can cause toxic or harmful effects. In any event all contaminants shall be kept to as low level as possible and shall be far below the national exposure limit”
21% +/- 1%
Must be as low as possible but not more than 5 ml/m³
Not more than 500ml/m³
Not more than 0.5mg/m³
Without significant odour/taste
Air up to 40 bar for compressed air breathing apparatus should have a pressure dew point sufficiently low to prevent condensation and freezing. Where the apparatus is used and stored at a known temperature, the pressure dew point should be at least 5°C below the lowest likely temperature. Where the conditions of usage and storage of the compressed air supply is not known, the pressure dew point should not exceed -11°C.
How can Air Mech assist?
We can give you peace of mind. Having performed breathing air testing for several years, we can assure that the RPE used by your staff complies with current regulations, ensuring their safety.
We can visit site, evaluate your equipment and supply a personalised maintenance schedule which suits your requirements, whether it’s a single test or multiple test points. On completion, test certificates are produced for your records so that your paperwork is kept up-to-date.
Air Mech also offer a range of filtration and purification equipment designed to meet/exceed the breathing air recommendations listed above. Contact us for more info on 02476 345658.
Why Air Mech?
Air Mech will guide you through the entire Compressed Air Quality Testing Process. In addition, our service includes Commissioning and testing to make sure your installation is safe.
Reach Out - See How Much You Can Save!
CALL FREE: 024 7634 5658